Adjustable Napkin Holder - from 170mm to 220mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
One napkin holder for all napkins.The model adjusts with a simple snap-click system, no screws and no tools needed:…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 12
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
One napkin holder for all napkins.
The model adjusts with a simple snap-click system, no screws and no tools needed: just slide the two side panels on the base and lock them in the desired position, from 170mm to 220mm.
The pins slide into the slots on the base and snap into place, keeping napkins always straight and compact, whether they are small or large.
In the centre there is a cross-shaped foot that keeps the yellow base at the same level as the two side panels, for perfect stability even when fully extended.
Hexagonal honeycomb perforated design: lightweight, uses less material, easy to print and with a modern look.
🧩 Parts List
N.2 Side panels - black
N.4 Pins
N.1 Base
N.1 Central foot
🖨 Recommended Print Settings
Material: PLA / PETG
Layer height: 0.20 mm
Infill: 15-20%
Supports: Not required
Adhesion: Light brim only for the side panels, if needed
Orientation: Base flat, side panels vertical
Colour in photos: Yellow + Black
Total print time: approx. 4-5 hours (depending on printer and speed)
It assembles in a few seconds, without glue. The pins press-fit into the slots.
Perfect for kitchen, table, dining room, restaurants and bars.
❤ Follow and leave a like!
If you like the model, follow me so you don't miss my next projects, leave a like and share photos of your print! It helps me a lot to keep creating new free models for everyone. Thank you!
💼 Commercial Licence - Physical Prints
This model is free for personal use. If you want to sell physical prints of this napkin holder, you can get the commercial licence by subscribing to my Patreon: https://www.patreon.com/vinors3dlab
The commercial licence allows you to print and sell the finished physical model. Reselling or sharing the digital files (STL / 3MF) is not allowed.