Stand for Dual Mvave FM1 Synths / TE EP-133 K.O Sampler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sturdy all-in-one angled stand for these three pieces of gear. Extra storage space below & optional "wood" side panels!
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 107
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Stand for dual Fm-1 Synths and TE EP-133 K.O. ii
I figured others could get some use out of this stand (I've been really liking it myself!)
I wanted something that would contain everything in one sturdy module. Each piece of gear locks into place using cutouts for each foot pad, but can easily be lifted out/disconnected for solo use. Easy cable routing to each piece with a good amount of room to stuff everything down below!
Main Assembly: Just need to CA super glue the 4 main pieces together (pegs/holes help to line everything up), this is all you need if you don't want/have filament for: PLA Wood side panels, TPU passthrough and footpads.
Optional Assembly: Lightly sand, stain (I used gel stain), and finish (I used shellac) the PLA Wood side panels for that “real wood” look. Glue each side panel into place. Next glue the TPU passthrough into place, followed by the TPU feet pads.

Happy Printing!