Mac Pro Bumper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
As I needed to place my Mac Pro beneath my desk for a while, where I constantly bashing my chair into it, I needed a…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 282
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
As I needed to place my Mac Pro beneath my desk for a while, where I constantly bashing my chair into it, I needed a solution to preserv my presious alu-wonder-machine.
Designed a quick "snap on" bumper to be placed on top, bottom or both, so that it will take up some of the force whenever I forget that there is a machine under my desk ..
Included two versions, as not everyone (me included) have large enough print bed to go beyond 200mm
Print Settings
Printer Brand:
Prusa
Printer:
Prusa Steel
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
Doesnt matter
Filament: Generic PLA Grey
Notes:
Would recommend using a brim if you dont have "the best" of adhesion.
Category: DIY