1 / 4
Stick-on cable clip set for gauge wiring, Ø 3–6 mm – free — zdjęcie 1
1 / 4

Stick-on cable clip set for gauge wiring, Ø 3–6 mm – free

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Nine stick-on clips in three sizes (3, 4.5, 6 mm) for tidy gauge wiring behind trim. No supports.

Ocena
0 / 5
Polubienia
1
Pobrania
2
Wydruki
0
Wyświetlenia
5
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial

Nine stick-on clips in three sizes to route the wiring of add-on gauges neatly behind trim and under the dashboard.

When fitting an add-on gauge, the wiring is often the untidy part. This set of nine stick-on clips routes it neatly along trim, the A-pillar or under the dashboard.

  • Three sizes, three of each: for cables or bundles of Ø 3, 4.5 and 6 mm.

  • 16 × 8 mm bonding area for double-sided tape (e.g. VHB).

  • The cable is pressed into the open ring from above and can be taken out again.

  • Prints on edge without supports; the clips hang on thin bars and are snapped off.

Free, because it is useful on its own and complements every gauge install.

Variants (all included)

  • Set of 9 clips (3 × Ø 3 / 4.5 / 6 mm)

Included

  • STL, 3MF and STEP for every variant

  • README with print settings and installation (EN/DE)

Safety

Do not route cables through airbag deployment zones (A-pillar with curtain airbag, steering wheel, passenger door) and do not stick clips there. Use ASA or ABS in the sun, no PLA.

Hardware (not included)

  • 9 × Double-sided tape (e.g. VHB), 16 × 8 mm per clip

Fit

If a cable does not hold: use the next smaller clip.

FAQ

Which tape? Double-sided foam tape, e.g. 3M VHB, on a clean, grease-free surface.

How it's made

Parametric CAD (build123d, Python), exact solids. The CAD code was written with an AI assistant and checked by us; no AI-generated meshes. Renders are made from the CAD in Blender.

License

CC BY-NC 4.0: you may share and adapt it for non-commercial purposes, as long as you credit Magmacode and link the license (https://creativecommons.org/licenses/by-nc/4.0/). Commercial sale of printed parts only by written agreement with Magmacode.

Not an original part, no affiliation with any vehicle manufacturer.

Tagi