1 / 3
Echo Dot 3 (donut) Pogo Pin Holder for TM3 / TM4 / TM5 - solderless jig — zdjęcie 1
1 / 3

Echo Dot 3 (donut) Pogo Pin Holder for TM3 / TM4 / TM5 - solderless jig

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Small solderless jig for USB access on the Echo Dot 3rd gen (2018, codename donut, model D9N29T).

Ocena
0 / 5
Polubienia
1
Pobrania
12
Wydruki
0
Wyświetlenia
153
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

Small solderless jig for USB access on the Echo Dot 3rd gen (2018, codename donut, model D9N29T). It holds three pogo pins on the TM3 / TM4 / TM5 test pads, so you don't have to solder wires to the board for kamakiri / TWRP flashing.

  • Slides over the grey standoff next to the pads. The small brace on the standoff keys into a slot, so the holder always sits in the same position.

  • Fixed with the device's original screw. No extra hardware needed.

  • The underside is left open, so you can see the pin tips touching the pads.

  • The outer pins lean outward by 8°, so 2.0 mm pins fit the pad spacing with printable walls between them.

You need: 3× pointed pogo pins with a 2.0 mm body, and a USB cable with the wires connected to the tops of the pins.

Print settings (Bambu Studio):

  • Layer height 0.12 mm

  • Material: PETG

  • Enable Auto circle contour-hole compensation under Quality. The hole sizes are tuned with it on, and without it the pins won't fit correctly.

  • No supports. The model is already oriented, flat top face down.

Assembly: press the pins into the holes. Mount the holder on the standoff and screw it down. Each pin should compress slightly against its pad. In case having a trouble to get good grip on the pogo pins secure them with Blu-Tack.

Created with Claude.

Tagi