Quest 3 ETVR, Vive, and Face tracker mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Find your own Eye Tracking rings though.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 21
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a ETVR setup to be used on a quest 3, that has a lug for the face tracker that can be magnetically flipped up, and has a mounting point for a vive or tundra tracker on top. Requires some cutting for the ribbon cables to go through the face gasket. Be sure to remove the IR filters from the OV2640 cameras!
2x ETVR V4 Lite
2x 150ohm resistors (to use with the ETVR Lite. the recommended and included resistors are 130ohm for each eye as an individual module, but the IR is dimmer using a 150 ohm resistor, and doesn't overwhelm the IR cameras as much)
3x Xiao Sense ESP32 with heatsinks (7x14mm is good)
2x 130 degree OV2640 IR camera 75mm (or 150mm if you can find that)
2x fpc extender (not needed if you get 150mm cameras)
2x fpc cable (not needed if you get 150mm cameras)
1x 130 or 160 degree OV2640 IR camera (short, original xiao sense size)
1x Adafruit CH334F Mini 4-port USB Hub
5x USB C male connector (three for the USB hub, two for the usb c cable to power the hub)
optional 6th usb c male connector if you want to give your vive or tundra tracker a steady 5v feed.
4x M2 heatset inserts
4x M2 screws 6mm length
2x M3 heatset inserts
2x M3 screws 6mm length countersunk
2x M4 nuts
2x M4 screw or thumbscrews for babble mounting, ~ 15mm-20mm
2x 10mmx1mm thin round magnets (the flip up magnetic babble mount may need some additional trimming of the pockets where the magnets sit)
8x 6mmx3mm magnets
1x flat head ¼-20 x 3/8" screw
for eye rings, try: