Spinning SKZ Lightstick.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It is a "lightstick" that can be spun with a handle! Based off the Stray Kids stick.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 12
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Share Alike
This is a "lightstick" that nearly looks like the Stray Kids lightstick! It looks like the real deal if you step back far enough, and you can play with it as much as you want.
It should be a rather simple assembly. It uses bevel gears to rotate, but I dunno how well they will work because I just design, no print.
ASSEMBLY

We begin with the STICK part. this is like the box that holds your whole thing together.

Next, pop in a WASHER. This should spin freely in place.

Take the HANDLEGEAR and enter in from inside. It may be a close fit, but there should be a couple of millimetres of wiggle room remaining.

Put the SPIN piece inside and fiddle with it until the square holes align. Also try to align the teeth on the gears. The squares don't have to be aligned with anything, so just worry about the hole.

Then, take the SHAFT piece and insert the rod into the mechanism. You may notice that one side has 2 squares. That side goes down.

Pop the CAP piece on to keep everything in place.

You may notice how the cap rests on this ring piece of the SHAFT. Make sure to glue the cap to the STICK, not the SHAFT as we want the SHAFT to spin freely.

Take the SAUCER piece and glue it on top of everything. Now, the SHAFT should only be able to spin.

Almost done now! Take the DISPLAY part and glue to the SHAFT. Test if it can spin from the handle.

Attach the handle on. FINISHED!!! Now you can be a Stay on a budget. If you just printed the stick, saucer, and display. you could probably make a static stick.