UniFi Dream Wall XGS-PON SFP+ Cooler – Side-Mounted 25 mm Fan (Zaram / Potron)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clip-on 25 mm side-fan cooler for XGS-PON SFP+ sticks in UniFi Dream Wall. Tested: Zaram ZXOS11NPI, Potron X-ONU-SFPP.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 31
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Designed for the UniFi Dream Wall
Replacing your ISP’s ONT with an XGS-PON SFP+ stick in the UniFi Dream Wall works well, but the stick runs hot: the Dream Wall gives the SFP+ cage very little airflow. This shroud clips onto the exposed part of the stick and puts a 25×25×10 mm fan right next to it.
The fan is mounted on the left side and and fits the limited space around the bottom Dream Wall’s SFP+ port. Three contact ribs per side hold the stick snugly sideways, small lips snap under it and ridges on top stop it moving up and down.
Tested sticks
Zaram ZXOS11NPI
Potron X-ONU-SFPP
Other SFP+ sticks with a similar exposed size should fit too.
What you need
1× 25×25×10 mm fan, 5 V or 12 V depending on what power you have available
4× self-tapping fan screws (2.0 mm pilot holes; M2.5 recommended)
Something to power the fan. I repurposed an old 12V power supply adapter and directly soldered its wires to the fan.
Print settings
Material: PETG or ASA recommended as the SFP+ sticks run hot, avoid PLA
Nozzle: 0.4 mm (walls are sized as multiples of 0.4 mm)
Layer height: 0.2 mm
Orientation: roof side down on the bed.
Supports: yes, for the window tops, the chamber floor and the top of the fan opening
Infill: 20% or more (most of the part is walls anyway)
Designed in Fusion with lots of print-test iterations; feedback and remixes welcome.