Pluvio, Rainfall Cylinder Lamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rain streaks cut through a cylinder lamp glow from inside. Swap the Diffuser colour; twist lock, no supports, two sizes.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 16
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Pluvio
Rain runs down this cylinder and bursts open on the top. The streaks are cut clean through the wall and run over the top edge, so with the light on, only the rain lights up.
The round sibling of Pluvia. For a desk, a shelf or a bedside table. Runs on a standard 60 mm USB LED light kit and twists and clips together without glue or screws.
Swap the glow
The colour comes from the Diffuser, a thin insert printed in Spiral vase. Print a few in different colours: pull the Sleeve gently off the Lock ring, swap the Diffuser and clip the Sleeve back on.
Both lamps in the photos have an orange Diffuser, one in a blue Sleeve and one in a red Sleeve.
Two sizes
You will need
One 60 mm LED light kit, USB, 5 V. Nothing else.
Printing
Both sizes have two plates:
Base and Sleeve: the Base, the Lock ring and the Sleeve.
Diffuser components: the Diffuser and the Diffuser cap, already set to Spiral vase on the plate.
The settings are already in the files. Printing from your own profile? Use these:
Wall generator: Arachne, for every part.
Diffuser and Diffuser cap: Spiral vase.
Sleeve: 3 walls, wall order outer/inner.
Base and Lock ring: concentric top surface, 7 % gyroid infill.
Supports: off.
Print the Diffuser in a light or translucent filament, so the glow comes through.
Assembly
Drop the LED light into the Base and lead the cable out through the slot.
Twist the Lock ring onto the Base until it stops.
Lay the Diffuser cap on the Lock ring and push the Diffuser onto it.
Clip the Sleeve onto the Lock ring, over the edge that runs around it.
Parts
Base, Lock ring, Sleeve, Diffuser and Diffuser cap.