Bishop X Critical Shorty: Extended Battery Shell (fits 25 mm cells)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement top shell for the Bishop X Critical Shorty tattoo machine battery.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 3
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
Disclaimer: This is my first design attempt ever. Feedback is welcome. Thanks!
A replacement top shell for the Bishop X Critical Shorty tattoo machine battery. It’s about 19.5 mm deeper than stock, so you can fit a standard off-the-shelf LiPo after the original custom-size cells swell and die. It keeps the OEM lid, the display window, the PCB slots and the lid screw positions.
What you need
Your original OEM shorty battery pack; disassembled. You will use all of the original parts except the main shell, dead battery, and the screws.
A single-cell 3.7 V LiPo with a built-in protection circuit. It’s designed around a cell of about 25 mm wide, up to 10 mm thick and 40 mm long, such as a 102540. This gives it 1100 mah of use.
2 × M2 × 10 mm self-tapping screws.
Assembly notes
Disassemble your shorty pack by lifting up the rubber on the bottom and removing the two screws. Use an exacto knife to lift the sticker covering the display and rubber buttons
Slide everything out. Be careful with the LiPo cells as they may be inflated and pose a fire hazard.
Desolder the old battery.
Solder on the new battery. CHECK THE POS AND NEG ORIENTATION! Leave the battery leads long enough so you can rotate/adjust the battery orientation in the shell.
Slide the secondary PCB in first into the forward most channel, with its ribbon trailing up, then slide the main PCB into the second channel in until it stops. The stop lines up the display with the window.
Seat the cell, close the lid and fasten the two screws.
Replace the rubber buttons and then re-apply the sticker.
Print settings
Material: ASA (black), also a good match for the original look. PETG works too. Avoid PLA, because it softens near a warm cell.
Orientation: rim facing up. No supports needed.
At least 3 perimeters. The PCB grooves have thin walls.
Brim recommended for ASA. Infill 25–30%.
Tested
Both PCBs slide in cleanly and the screw positions line up.
Safety
Swollen LiPo cells are a fire risk. Don’t puncture or squeeze them, and take them to a battery recycling drop-off. Use a protected cell, and check the fit and wiring before you close the case. You’re modifying your own equipment at your own risk.
Disclaimer
Not affiliated with or endorsed by Bishop or Critical or its makers. Dimensions are measured from one unit, so check them against yours before printing.
Files: the STL plus the parametric OpenSCAD source (bishop_shell.scad) so people can adjust the depth, lip and fit.