Rekon 7 Modifications
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
• Water-repellent electronics cover • LED arm end covers
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 17
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
What’s included
Electronics cover: side covers and a top lid that enclose the flight stack. Tested in mild rain.
Camera mounting options: mounts for different camera setups.
GPS top plate modification: a mount designed for the ARK M10 GPS, sitting on the top plate.
Built around
Rekon 7 frame
ARK FPV flight controller (30.5 × 30.5 mm)
ARK M10 GPS
Print recommendations
Covers and mounts: Everything was designed to be printed with ASA
Walls: at least 3 perimeters on the covers for water resistance.
Supports: as needed depending on orientation.
Notes
Rain-resistant, not waterproof. Conformal-coat your electronics for extra protection. The print should also be vapor smoothed to help with water proofing.
Make sure your VTX gets airflow if it’s mounted inside the cover. This was designed for winter conditions; it will most likely overheat if you don't have the same conditions.
Not affiliated with Rekon or ARK Electronics.
Specs
Frame: Rekon 7 (7")
Flight controller: ARK FPV running PX4. 30.5mm standard mounting pattern, supporting a 3-12s battery input with a regulated 12V 2A output for video transmitters and payloads. px4
ESC: Hobbywing 4-in-1 (30.5 × 30.5 mm)
Motors: iFlight XING2 2809 1250KV.
Props: 7"
VTX: Foxeer Reaper Extreme.
FPV camera: Foxeer T-Rex Micro
VTX antenna: TrueRC, RHCP
GPS: ARK M10
Optical flow: ARK Flow LR (DroneCAN)
Still to Come
ARK Optical Flow mounting
Improved ARK M10 GPS mounting
Improved Camera Mounting