YAYA bunny robot tracker

HERE IS MY NEW ROBOT!! 

IT'S NAMED !!!!! NESSIE 

this page contains:

• the particularity and robot competence 

• the component list 

• the assembly guide!

• where to found the code if you're intersted

OKAY! let's start with the robot use and competence this robot can in theory : 

• track people with a camera 

• go to a certains target using a map on your phone 

• you can command it by youself to 

• you can talk to 

the case is design to don't force you to glue things and to make the component and part removable  and to not use the 3d part while removing or adding new thing!

THE COMPONENT LIST! 

• for only ONE component you can use glue or scotch (but not force to )

• thermal insert x50 but not force to use them all it will fix sometimes without fixing all holes

• screw M2  x90 but they're not usefull 

• a string or scotch (anything you want but a hose clamp or scotch is way better it's to fix the battery)

• bolt 12x

THE ASSEMBY GUIDE

• first print all the part ( hehe)

• then take the bottom piece (flat one)

• then put first the buzze for the battery (with glue/ scotch / what you want)

• after that place the servo_bus_driver

• place the battery with the cable adaptator, also the voltage adaptator

•  add the big ST motor ( the red dot is the screw you may use the bolt for transition Motor 1 to motor 2

• finish the leg and repeat for each 

• then lets put the first edges to layer up (before that start soldering the composant of the 1st layer ) use srew to fix the edges

• than put the midle layer the pcb  ( including the raxda and all the component because they need to be fix with srcew thought pcb and then 3Dpiece) don"t forge tthe multiplexer because mine i put it on the pcb

• then solder or if you have a pcb connect. AND AFTER put the head  and sgservo motor (don't forget to use srew to fix things)

• then put the speaker, oled and camera on the and and connect

•  put the top  to put the lidar and the microphone( make the wire go thought the little hole for microphone)

• near to the end!!! just use screw and fix the 2 edge

well playyy you finish it!

 to found anything and the code my github is : https://github.com/ysxaybarroso-ux/my-first-hardware-robot-yaya i'm very new to the world of electronic and info 

fun fact if i didi this :

reason one i'm a fan of ROBOT (titanfall, pacific rim, tranformer, generation 0, armored core, and a lot more) i tell myself okay no holding back start with a super difficult thing and then see ( maybe not a good advice hehe) 

then i dream to have a robot friend as a kid so maybe my dream can come true as now i'm growing up!!!