3lb grapnel style anchor for float tube fishing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed a small anchor while float tube fishing in the harbor to hold me from drifting due to small currents (tides)…
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 645
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution
I needed a small anchor while float tube fishing in the harbor to hold me from drifting due to small currents (tides) and light breezes. After a little research, a 3 lb anchor seemed to be about right for this.
Having several 1 1/2" pvc (~40 mm ID) pipes laying around I thought about 18" section filled with concrete would work fine. Since the harbor is mostly sand bottom, I added some legs to grab the bottom a little better.
I glued the bottom cap into the pvc pipe using gurilla glue. I mixed up concrete and poured it into the tube, filling it almost to the top, allowing room for the printed top cap. I let the concrete set for 1 day before gluing on the top cap.
The legs are hinged onto the bottom cap ears using 1/8" nylon bolts and nuts.
I use a 50' line to tie the tether the anchor to the float tube. The harbors are usually 25-35 feet in depth.
I store the anchor in the arm of the float tube. The legs are folded onto the main body.
The 4 hinged legs on the bottom cap manually expanded before dropping it in the water.
I was asked "why do this when you can buy an anchor off amazon for ~$12.00"?
- I had the materials already.
- I get something exactly what I want.
- Metal and saltwater don't like each other. This will never rust.
- Because I just like doing DIY stuff.
Print Settings
Printer Brand:
Ultimaker
Printer:
Ultimaker 3
Rafts:
No
Supports:
No
Resolution:
200
Infill:
100
Filament: inland PETG clear
Category: Sport & Outdoors