1 / 5
Christmas Sweater Coasters — zdjęcie 1
1 / 5

Christmas Sweater Coasters

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Four Nordic sweater coasters with real knit stitch texture, plus a matching holder. Multicolor, no supports.

Ocena
0 / 5
Polubienia
2
Pobrania
2
Wydruki
0
Wyświetlenia
12
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Four round coasters (Ø 100 mm, 5 mm thick) with the look of an ugly-in-a-good-way Christmas jumper: snowflake, reindeer, three fir trees and a Selbu star, each framed by small diamond borders. Every stitch is a raised V, so the top feels like knitted wool, not a flat pixel grid.

The colors are only in the top 0.8 mm (4 layers at 0.2 mm). Everything below is cream, so tool changes happen on 4 layers only.

  • Colors: 1 cream, 2 red, 3 fir green, 4 gold

  • Layer height 0.2 mm, 3 perimeters, 15 % infill, no supports

  • Plate 1: three coasters, about 2 h 50, 12 tool changes

  • Plate 2: the star coaster + the holder, about 2 h 10, 34 tool changes

  • Holder: one color, ribbed like a sweater cuff, holds the four coasters, open at the front so you can slide one out. Finger hole in the base to push the stack up.

The 3MF files are set up for the Prusa Core One INDX (4 tools). On an MMU or another multi-tool printer, open the 3MF and pick your filaments; single STL files per color are included.

Tip: PLA is fine for cold and warm drinks. A freshly poured tea straight from the kettle is fine too, but don't leave a hot pan on them.


Français

Quatre dessous de verre ronds (Ø 100 mm, 5 mm d'épaisseur) façon pull de Noël nordique : flocon, renne, trois sapins et étoile de Selbu, encadrés de petites frises en losanges. Chaque maille est un V en relief : on sent le tricot sous le doigt.

Les couleurs n'occupent que les 0,8 mm du dessus (4 couches de 0,2 mm) ; tout le reste est crème, donc les changements d'outil se limitent à ces 4 couches.

  • Couleurs : 1 crème, 2 rouge, 3 vert sapin, 4 or

  • Couches de 0,2 mm, 3 périmètres, remplissage 15 %, sans supports

  • Plateau 1 : trois dessous, environ 2 h 50, 12 changements d'outil

  • Plateau 2 : le dessous « étoile » + le porte-dessous, environ 2 h 10, 34 changements d'outil

  • Porte-dessous : une couleur, côtes de tricot comme un poignet de pull, ouvert devant pour sortir un dessous, trou au fond pour pousser la pile.

Les 3MF sont réglés pour la Prusa Core One INDX (4 outils). Sur MMU ou autre multi-outil, ouvrez le 3MF et choisissez vos filaments ; un STL par couleur est fourni.

Tagi