Sutrah (Prayer Barrier) - Open Arch Frame with Geometric Border and Base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Freestanding 47 cm sutrah for salah: open arch window with a geometric lattice border. Fits a 256 mm bed.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 11
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A sutrah is an object placed in front of a person performing salah to mark the edge of their prayer space, so that others know not to walk directly in front of them. This version is a lighter, open design: a tall pointed-arch window framed by a border of Islamic geometric star lattice, standing in a stepped base. It uses less filament than my solid lattice panel and prints faster.
Dimensions
Frame: 119 x 10 x 450 mm
Base: 250 x 120 x 30 mm, with a 117 x 10 mm slot about 9 mm deep
Assembled height: about 471 mm (18.5 in)
Files
sutrah_arch_cut_for_256_bed.3mf: ready-to-print project. The frame is already cut into an upper and lower half joined by four dowel pins, all on one plate. Use this if your bed is around 256 x 256 mm.
sutrah_arch_frame_full.stl: the full uncut frame, for large-format printers or if you want to make your own cut.
sutrah_base.stl: the base (not included in the 3MF, print it separately).
Print settings
Printer used: Elegoo Centauri Carbon, 0.4 mm nozzle, textured PEI plate
Material: PETG (Elegoo Rapid PETG), 250 °C nozzle, 70 °C bed. PLA also works for indoor use.
Layer height: 0.2 mm
Walls: 2, top and bottom layers: 3
Infill: 7 % grid
Supports: none. Print the frame halves lying flat and the base flat side down.
Brim: not needed on a textured plate. Add a small outer brim if the long legs lift.
Assembly
Print the two frame halves, the four dowel pins and the base.
Press the four dowel pins into the holes of one half. Add a drop of super glue if you want a permanent joint.
Push the other half onto the dowels until the cut faces meet and the lattice border lines up.
Slide the bottom edge of the frame into the slot in the base. It is a snug fit, so it can be left unglued for flat storage and transport.
Notes
If the dowels are too tight, sand them lightly or scale them down 2 to 3 % in X and Y.
The base is the same one used by my geometric lattice panel sutrah, so the two tops are interchangeable.
The cover image is a render of the assembled model.