Arduino Uno Snug Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is my remix Esquilo's Arduino case. I think the intention behind the original design was to create a smart…
- Ocena
- 5 / 5
- Polubienia
- 44
- Pobrania
- 245
- Wydruki
- 7
- Wyświetlenia
- 890
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is my remix Esquilo's Arduino case.
I think the intention behind the original design was to create a smart looking case to house a finished project.
My remix isn't as pretty as it is intended to be a permanent home for my prototyping Arduino with the greater emphasis on ease of use. The main difference being that holes in the lid are bigger allowing a view of the pin label, printed on the circuit board.
Other Modification:
Some supports on the lid hole the Arduino secure without the need for screws.
Most of the lid has been made thinner so it can act as window... sort of :), if made of transparent material.
Added two more clips at front and back to hold lid secure.
Hole to reset button is larger fore easy access.
Print Settings
Printer Brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
No
Supports:
No
Resolution:
0.4 nozzle __ 0.2 mm layer thickness
Infill:
20%
Notes:
top & bottom shell thickness was set to 0.8mm. if u set it lower u might get infill rather than a solid window on the lid.
Category: Electronics