CoralBoard Display: 7" touchscreen case with a flip-up camera
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Synaptics CoralBoard, a Waveshare 7" DSI touchscreen, and a OV5647 camera into one tidy device.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 64
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This case turns a Synaptics CoralBoard SL and a Waveshare 7" DSI touchscreen into one tidy device that looks finished from the front. The board sits behind the screen with a small fan to keep it cool, and the display is screwed in between the bezel and the rear case, so nothing moves or rattles. I only used parts the Synaptics Coral team has already tested with the board: the 7" Waveshare display and the OV5647 camera are both on their list of supported components, so they work with the standard software image and you don't have to hunt for drivers.
The camera is what makes it so flexible. Folded down, it sits flush in the back and looks at whatever is behind the screen: a 3D printer, a doorway, or a table full of objects for a live detection demo. Flip it up over the top edge and it becomes a webcam above the screen, for video calls, a dashboard that wakes up when you walk over, or a check-in kiosk. Leave the camera out and you still have a neat touchscreen computer for a Home Assistant panel, a machine control panel or a photo frame. It stands on a desk with the fold-out kickstand, or goes on a wall or a monitor arm using the VESA 75 holes on the back.
Everything prints in PETG with a 0.4 mm nozzle, and the logo is a flush second color, so there's no painting (it prints fine in one color too). There are two backs to choose from: Product, which is closed and clean, and Dev, which leaves the GPIO, mikroBUS, boot and JTAG open with the pin names printed next to them. Besides the board and the screen, you need an Arducam B006604N camera (the 20 cm cable version), a 30 × 30 × 6 mm 5 V fan, 6 M3 and 4 M4 heat-set inserts, 5 M3×20 screws, 1 M3×8 countersunk, 4 M2.5×5 (often included with the screen), 4 M4×10 countersunk, and an 84 mm piece of M3 threaded rod for the kickstand. The animation below shows how it all goes together. One tip: use a 75 mm VESA plate, because a 100 mm one gets in the way of the camera.
Assembly:
