1 / 5
Vmaisi Encased Magnetic Cabinet Lock Key — zdjęcie 1
1 / 5

Vmaisi Encased Magnetic Cabinet Lock Key

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A replacement key handle for Vmaisi-style magnetic child-safety cabinet locks.

Ocena
0 / 5
Polubienia
1
Pobrania
1
Wydruki
0
Wyświetlenia
11
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Here's a description you can paste into MakerWorld:


Encased Magnetic Cabinet Lock Key (Vmaisi-style)

A replacement key handle for Vmaisi-style magnetic child-safety cabinet locks. Unlike open-pocket designs, the magnet is fully sealed inside the print. There's no glue, nothing to pop out, and no exposed magnet for little hands to pry loose.

Lost or broke your key but still have the magnet? Pause the print, drop the magnet in, and resume. The printer seals it in for you.

Magnet size
Designed for the original magnet salvaged from a Vmaisi key: 20 mm diameter × 8.2 mm thick (measured with calipers). The ¾" × ¼" size quoted elsewhere is a little small for this magnet. Measure yours before printing.

How it works

  • Prints narrow face down. That flat face is the side you hold against the lock.

  • A thin 0.6 mm floor keeps the magnet close to the surface for full holding strength.

  • A snug press-fit pocket (20.2 mm) holds the magnet in place.

  • An air gap above the magnet lets the lid bridge cleanly instead of smearing onto the metal.

  • The tapered handle widens to 1¼" at a rounded top for an easy grip. It's 1" tall overall.

Print settings

  • Layer height: 0.2 mm (the pause position depends on it)

  • Pause: Z 9.6 mm (already set in the 3MF)

  • Supports: none

  • Turn on Thick bridges (Quality → Bridging) for a clean lid over the magnet

Inserting the magnet

  1. When the printer pauses, press the magnet all the way to the bottom of the pocket.

  2. Put the side that faced the lock in your old key facing down.

  3. Lay a card across the pocket. It shouldn't touch the magnet.

  4. Resume the print.

If the pause doesn't show on the layer slider after slicing, right-click the 9.6 mm layer and choose Add Pause.

Tagi