LSI 9305-16i 50mm Blower Fan Shroud
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This fan shroud has been adapted from an axial fan to a blower-style fan for maximum space savings in a compact case.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- GNU General Public License v2.0
I really wanted to slim this design down and fit it in my case, so I used a blower fan design instead of a traditional fan to leave room for the front panel headers on the motherboard. This takes up less than a full width PCIe slot as well, for those with limited room above the HBA.
Not a huge fan (heh) of the airflow doing a complete 180 as it comes out the fan, but my options were limited to get the air over the heatsink fins while still leaving plenty of room around the SAS connectors. Airflow seems to be adequate but I haven't ran temp tests yet. ;)
This uses a standard 5010 blower-style fan, in my case a Delta Electronics BFB0512HHA dual-ball-bearing fan that can be found for $10-15. The screw holes should fit a standard M3x10 machine screw, of whatever head style you prefer. (I had plenty of Phillips flavor laying around from other projects.)
I printed the model as shown in the Orca screenshot out of generic PETG, but make sure your filament is dry to avoid weak spots from moisture bubbles. I'd avoid PLA in case it warps from the heatsink warmth. Intended wall width is 0.4mm.