K1 Plus Metal Blade Scraper - Flipped Blade Orientation
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Blade orientation flipped for single angled blades. Widened thumb stop cavity and made thumb pad cavity more ergonomic.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 4
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model scraper builds on Yerg's design to create a K1 Plus Scraper replacement. Unlike the double edged blade that came with the original K1 Plus scraper, the ones that I purchased had a single beveled edge. They fit on Yerg's model, but the beveled edge was on the bottom. This model flips the blade, makes it easier to install the thumb knob and gives a bit more ergonomic rest for the pad of the thumb. This part should be printed top side down using a dissimilar support filament interface. In my case, I printed the parts in PETG and the support interface in PLA. This combination gives a much cleaner release than using the same material. For assembly, screw the thumb knob fully into the handle, with thread forming screws, prior to attempting to install the blade. After the thumb know is installed, back the screws out slightly to allow the blade to be inserted. Once inserted, tighten the screws. The thumb knob can also be glued in place. The blades that I purchased came with thread forming screws. The orange scraper is the remix in the photos.