FitDrawer Tray Kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Millimetre drawer bins, with a corner coupon for checking the wall and the radius.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 1
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Millimetre drawer bins, with a corner coupon for checking the wall and the radius.
This model was designed in OpenSCAD with AI coding assistance.
License: CC BY 4.0. You can share it and adapt it. Credit the design, link the license, and say what you changed.
Recommended print: PLA, 0.4 mm nozzle, 0.20 mm layers, 3 walls, 15% infill, no supports. Keep the STL as saved: floor on the bed, opening up.
The pictures are OpenSCAD renders.
Files and slicer estimates:
PrusaSlicer 2.7.2, generic PLA, the settings above. These lines are copied from the gcode summary.
• fitdrawer-bin-80x60x42.stl — Default bin, 80 × 60 × 42 mm, with the finger scoop. Slicer: estimated printing time (normal mode) = 2h 30m 14s. filament used [g] = 27.78.
• fitdrawer-coupon-36mm.stl — Corner coupon. The footprint is 36 mm; the sample is 26 mm tall. Slicer: estimated printing time (normal mode) = 31m 52s. filament used [g] = 4.83.
• fitdrawer-bin-100x80x48-2x2.stl — 100 × 80 × 48 mm bin with a 2 × 2 divider grid and a stacking foot. Slicer: estimated printing time (normal mode) = 5h 25m 29s. filament used [g] = 57.91.
• fitdrawer-bin-120x90x40.stl — A wider everyday bin, 120 × 90 × 40 mm, scoop on, no dividers. Slicer: estimated printing time (normal mode) = 4h 33m 46s. filament used [g] = 46.19.
The .scad is one file. Open it in the MakerWorld customizer or in OpenSCAD. No other file is required. Lettering uses Liberation Sans.
What you can change:
• Choose the bin, the 36 mm corner coupon, or both.
• Type the bin width, depth, and height, or switch on drawer fit and enter the drawer interior, the number of bins across and back, the gap between bins, and the gap at the walls.
• Set wall thickness, floor thickness, and corner radius.
• Set how many compartments run across the width and from front to back, and how thick the dividers are. One compartment in a direction means no divider there.
• Turn the front finger scoop on or off, and set how wide it is, how far it drops, and how deep it cuts.
• Set the stacking lip. Zero leaves a full foot. Above zero, the base steps in at 45 degrees so it nests in the bin below, and the floor thickens to keep that step solid.
No screws, magnets, or pads.
Share a make if you print it!