Slim weather balloon flight computer case (PTSolns Proto-Full)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Slim insulated case for a PTSolns Proto-Full v2.1 board. 211.5 x 69.2 x 65.4 mm. Untested draft.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 1
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Slim case for a weather balloon flight computer built on a PTSolns Proto-Full v2.1 solderable breadboard (200.7 x 58.4 mm). Outside size 211.5 x 69.2 x 65.4 mm. There are 2 inches of room above the board and a 3 mm gap all round for a foam liner. The board screws to four posts through its own M3 holes, and the lid screws into corner bosses. One end has a slot for the battery pack to poke out and a cable hole; the other end has a USB opening. Untested: this has not been printed yet, and the battery slot (58 x 18 mm pack) is a guess, so check it against your pack. Print in PETG, 0.2 mm layers, 3 perimeters, no supports. Base open side up, lid flat side down. Needs 8 x M3 x 8 mm screws. STEP files and the OpenSCAD source are included so you can change the dimensions.