1 / 5
Between-the-Frets Fretboard Sanding Caul Set – 7 radii from 7.25" to 16", 3 widths — zdjęcie 1
1 / 5

Between-the-Frets Fretboard Sanding Caul Set – 7 radii from 7.25" to 16", 3 widths

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Radiused sanding cauls narrow enough to fit between installed frets. 7 radii x 3 widths, radius engraved on each caul.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
1
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Sanding or polishing a fretboard after the frets are in is fiddly: a regular radius block is too wide, and a flat block rounds over the board. These cauls have a concave sanding face that follows your fretboard radius, and a narrow blade that slides between the frets.

What's in the set (21 STL files)

  • 7 radii: 7.25", 7.5", 9.5", 10", 12", 14" and 16" (the curve has 0.5 mm extra for sandpaper and tape)

  • 3 blade widths per radius: 7 mm fits between every fret, up to fret 22; 12 mm from the nut up to fret 16; 18 mm from the nut up to fret 10, faster on the wide low frets

  • The radius is engraved on top of the grip (7.25, 9.5, 12, ...), so you never mix them up

Fret positions are calculated for a 25.5" scale and a fret crown of about 2.6 mm. On a 24.75" scale the 7 mm blade still fits everywhere; use the narrower blade near the highest fret of the 12 and 18 mm ones.

The blade is 40 mm long (across the fretboard) and 4 mm tall, so it clears the frets. Total height is about 17 mm, with a 12 mm grip.

How to use

Stick a strip of sandpaper to the concave face with double-sided tape or spray adhesive, cut to the blade width. Slide the caul back and forth across the fretboard between two frets.

Printing

The files are already oriented with the flat top on the bed, so the concave sanding face prints on top and comes out smooth. No supports needed. The engraved number is in the first layers: avoid a squashed first layer (elephant foot), or the number fills in.

  • Printed on a FlashForge Adventurer 5M, PLA, 0.2 mm layers, 3 walls, 25 % infill, no supports

You also need

  • Sandpaper strips (e.g. 320 to 1000 grit)

  • Double-sided tape or spray adhesive

Designed and used in the Sixto Custom Guitars workshop (Belgium). More from the workshop: 666sixto666.github.io/SixtoTools/site

Tagi