Qubit Spinner Keychain
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a fun little Bloch sphere representation of a Quantum Bit (Qubit)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 8
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution
This is a Bloch sphere representation of a Qubit -- a Quantum Bit. Like my original design, this little device looks a lot like the letter "Q" and prints assembled. It also can spin very freely, even in response to blowing on it. However, this version gives the full two axes of rotation, not just one. In other words, this one is not just a cute toy, but a good physical aid for explaining superposition.
The top of the Qubit has a cavity that can accept a standard 1" diameter keychain loop, or cord/fishing line could be run through it to treat it as a pendant. The Qubit itself is approximately 42x42x5mm.
The original was designed to be a 3D-printed give-away for the Aggregate.Org research group, which is based in the Electrical and Computer Engineering Department of the University of Kentucky. It was first handed out in our research exhibit at SC18, and several hundred were given away there. Many thousands have been given away since then. This new version is distributed by QERKY.ORG, representing Quantum Education and Research in KentuckY. The Qubit has 0 and 1 printed on opposite sides of the central (theta) portion, no markings on the rotating (phi) ring, and QERKY.ORG discreetly printed on the back of the surrounding Q.
This design can be printed assembled on most consumer 3D printers without any alterations. If your printer can handle more than one color, make the text in a contrasting color. If not, print only the body, and you can paint-in the embossed text using an acrylic paint pen. Tolerancing is tuned for FDM printing PLA using a nozzle of approximately 0.4mm and an extrusion layer height of 0.2mm or less.