Filumen, Light Threads Cylinder Lamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Light threads run down this cylinder lamp and fan out over the top. Swap the glow, twist it together, no supports.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 13
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Filumen

Thin threads of light run down this cylinder. Some take a short step to the side at 45 degrees, and on the top they fan out from the centre. The threads are cut clean through the wall, so with the light on, only the threads glow.
For a desk, a shelf or a bedside table. Runs on a standard 60 mm USB LED light kit and twists and clips together without glue or screws.
Swap the glow

The colour comes from the Diffuser, a thin insert printed in Spiral vase. Print a few in different colours: pull the Sleeve gently off the Lock ring, swap the Diffuser and clip the Sleeve back on.
The lamp in the photos has a blue grey Sleeve, shown with two Diffusers: a sky blue one for the aqua glow and a second one for the warm ember glow.
One size

You will need
One 60 mm LED light kit, USB, 5 V. Nothing else.
Printing
Two plates:
Base and Sleeve: the Base, the Lock ring and the Sleeve.
Diffuser - Vase mode: the Diffuser, already set to Spiral vase on the plate.
The settings are already in the files. Printing from your own profile? Use these:
Wall generator: Arachne, for every part.
Diffuser: Spiral vase.
Sleeve: 3 walls, wall order outer/inner.
Base and Lock ring: concentric top surface, 7 % gyroid infill.
Supports: off.
Print the Diffuser in a light or translucent filament, so the glow comes through.
Assembly

Drop the LED light into the Base and lead the cable out through the slot.
Twist the Lock ring onto the Base until it stops.
Push the Diffuser onto the Lock ring.
Clip the Sleeve onto the Lock ring, over the edge that runs around it.
Parts

Base, Lock ring, Sleeve and Diffuser.
