Horbor Freight Storehouse 15-Bin Small Case Parts Bins
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Factory bins spilled small parts. Wanted split and curved bottom bins that didn't spill small parts.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 13
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
All started with a comletely unlreated issue. Needed some small wire furrels for a door access project. They came in a box that would pop open at the slightest touch so I picked up a Harbor Freight Storehouse 15-bin storage case. Great!! Not so great. With the top down the ferrules still popped out of the bins. $%#!!@... Turns out the bins are a few mm short of the top cover. The top cover also has small dimples that lock the corners of the bins.
So, a couple of ideas in the trash, followed by a few prototype boxes, I ended up with this design. They may be a bit overbuilt, but they work great! They push more or less flush to the inside lid when closed and have curved corners to fit properly into the lids corner dimples. Loaded up the bins with ferrules and shook the snot out of it and nothing popped out of its own tray. Nothings perfect but this works for me! :-)
I've included two types, full bin and split bin and each one is further split into side (two corner dimples) or center (four corner dimples).
I printed these with 3 walls and 10% infill. I used PETG (because that's all I had that wasn't black!) but I would think PLA would also work well. If I had modify these I'd probably make the walls and floor a skosh thinner - next time...
Hope you find these as usefull as I did!