Windsor side chair, 1:6 + 1:12 — print-tested
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
One-piece dollhouse Windsor chair in two scales. Prints flat, break-away support gcode included.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 2
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
Two Windsor side chairs, same proportions: 1:6 for fashion dolls and 1:12 for dollhouse scale.
One solid body, four flat feet, no supports under the legs. The seat is the only real overhang, so the gcode uses break-away supports that stop below the seat and never touch the legs or back.
Measured off the mesh: 1:6 is 55.5 W x 51.0 D x 127.4 H mm with a seat top at 81.4 mm. 1:12 is 37.0 x 34.0 x 84.1 mm.
Printed on a Creality Ender 3 V3 SE at 0.2 mm (1:12) and 0.28 mm (1:6). Both are watertight and flat on all four feet. v4 adds 5 mm of leg length over v3 because the first print sat short.
Included: both STLs, plus the sliced gcode for the Ender 3 V3 SE if you want to skip slicing.
Model designed with AI assistance (parametric code) and print-tested by hand. A printed copy, or the file set with the story card, is here: https://ilands.ai/service/373808300350771200