CR10/Ender 3 Extruder Chain with Filament Runout Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I remixed this using two different things on Thingiverse. I needed this in order to allow for a secure place to…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 435
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I remixed this using two different things on Thingiverse. I needed this in order to allow for a secure place to attached my TH3D EZOut (https://www.th3dstudio.com/product/ezout-v2-filament-sensor-kit-or-bl-touch-adapter-board/) and the chain that I printed for my my cable management. I hope this helps people out there in the same situation.
I end up getting a drill bit that was the exact size of the holes in the EZOut. I placed the EZOut in the filament runout's tray and drilled through the print. I then screwed it down with 2 M4x25 screws.
I found the best way to print this is to flip it 180 degrees on the Y axis with supports from the bed only.
Update Feb 9th: After using this a bit, I would like to find a way to make loading filament a little easier. Currently I have to use tweezers to help guide the filament but there might be something else that can be done. I will post a new version once I figure out a fix.
Print Settings
Printer:
Creality Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
100
Filament:
Inland PETg
Blue
Category: 3D Printing