1 / 3
TOADs DI + DI6/DI8 Box - Magnetic Lid (No Screws) — zdjęcie 1
1 / 3

TOADs DI + DI6/DI8 Box - Magnetic Lid (No Screws)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A remix of the TOADs DB6 Box where four 6×2 mm magnets replace the lid screws, and locating lips keep the lid aligned.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
7
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

TOADs DI + DB6/DI8 Box – Magnetic Lid

This is a remix of @BBoyd_455561's TOADs DB6 Box, a compact case for the TOADs Digital Interface with the DI6 (or DI8) daughterboard. I liked the original design, but I wanted a lid I could pop off without a screwdriver. So I replaced the screws with four small magnets and added locating lips to keep the lid aligned. The board rails, port cutouts and size are unchanged, so it fits the same as the original.

What you need

Build instructions

  1. Test-fit the magnets. They should drop into the pockets with a little play. If a pocket is tight, clean it out with a 6 mm drill bit turned by hand.

  2. Glue the box magnets. Put a small drop of CA glue in each pocket of the box bosses and press a magnet in flush. Let it set.

  3. Get the polarity right. Stick a loose magnet onto each box magnet. The side now facing up is the side that goes into the lid facing down, toward the box. Mark it with a marker before you take it off.

  4. Glue the lid magnets. Glue them into the lid pockets with the marked side facing out. Let the glue cure fully before closing the lid, or the magnets can pull out of the wet glue.

  5. Install the boards. Slide the TOADs DI and DI6/DI8 stack into the rails from the open end until the USB-C and Mini DIN line up with the lid cutouts.

  6. Close it up. Hold the lid so the lips go into the bottom corners of the box. It will snap shut.

Print tips

  • Material: PLA or PETG both work. Use PETG if the box will sit in a hot car or near a radio that runs warm.

  • Box orientation: stand it on its closed end with the opening facing up. The 45° tapers under the magnet bosses let it print without supports, and the magnet pockets face up.

  • Lid orientation: print it outside face down. The locating lips point up, so no supports are needed.

  • Layer height: 0.2 mm is fine. 0.12–0.16 mm gives a smoother fit on the rails and lips.

  • Walls: 3 perimeters, 15–20% infill.

  • If the lid is tight: your printer may be over-extruding. Sand the outside faces of the lips lightly, or calibrate your flow.

The original is licensed CC BY-NC 4.0, and so is this remix. Please don’t sell the files or printed cases.