The Doors Jim Morrison Portrait & Logo Wall Display
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Print a 2-piece Jim Morrison portrait and The Doors logo wall plaque with modular display options.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 2
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Riders on the Storm for your studio, music room, or classic rock wall! This 3D display plaque pairs a bold, high-contrast silhouette portrait of Jim Morrison with the unmistakable geometric-mod typography of The Doors.
This model is part of my Slave To The Metal 90s Drawing Series /Collection, where I am systematically turning my original hand-drawn concept art of classic band logos into clean, printable display pieces.
Modular 2-Piece Assembly & Face Options:
Interlocking 2-Piece Display: Combines the Jim Morrison portrait and The Doors name logo into one dramatic 10" tall wall centerpiece.
Two Portrait Variations Included:
Interlocking Portrait: Features recessed inset cuts along the bottom edge so the portrait sits cleanly over and around the top of The Doors name logo.
Standalone Portrait: A clean, solid portrait version without bottom cutouts if you want to print and hang Jim Morrison on his own.
Dimensions
Overall Assembled Height: 10.0”
Total Thickness: 0.5”
Jim Morrison Portrait:
Width: 9.0”
Height: 8.0”
Thickness: 0.25”
Portrait Inset: 0.2186” (leaves 0.0314” actual face thickness at the recessed overlap)
Name Logo:
Text Width: 9.95”
Text Height: 2.85”
Text Thickness: "The" 0.125” / "Doors" 0.375”
Text Inset: 0.0625”
Mounting: Features (2) built-in keyhole slots on the back designed for #3 screws for a completely flush wall mount.
Print Settings
Material: PLA
Layer Height: 0.12mm to 0.20mm (Lower layer heights yield incredibly smooth results across the curvy letters and hair contours).
Infill: 10% or higher (Gyroid or Grid patterns work great).
Supports: None required when printed flat on the bed. (Note: Depending on your printer's bridging capabilities, light supports may help inside the bottom recessed inset cuts where the portrait connects to the name logo).
Looking for just the standalone name logo?
Check out my companion listing here:
Where It All Began:
Curious about the original hand-drawn concept art that inspired this whole series? Check out the model that started it all: