Lego Star Wars UCS Slave 1 (75060) Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This design allows you to wall mount your Lego Star Wars UCS Slave 1 vertically. After printing I had to file all the…
- Ocena
- 5 / 5
- Polubienia
- 95
- Pobrania
- 472
- Wydruki
- 3
- Wyświetlenia
- 4057
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Building Toys
- Licencja
- Creative Commons — Attribution — Noncommercial
This design allows you to wall mount your Lego Star Wars UCS Slave 1 vertically. After printing I had to file all the corners as my printer doesn't quite make them square.
I probably over-engineered this as I'm paranoid about it jumping off the wall! It uses two of the mounting holes from the original stand, plus four other locations. I also added holes for one or more Lego Technic pegs to hold the mount onto the ship. To fit: -
- Sand any bumpy edges on the mount square.
- Remove engines (which just pop out).
- Remove (or fold up) t-piece between engines.
- Fit ship side mount.
- Fit one or more technic pegs (one is fine).
- Slide onto wall side mount.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
50%
Filament:
Sunlu PLA
Notes:
If you're using Cura, I also like to set the "Infill Line Multiplyer" to 3, and the "Infil Pattern" to Cubic Subdivision
Category: Construction Toys