TUMBLING TINY TEDDY BEAR EXTRUDER VISUALISER
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This Tiny Teddy will disrupt your workflow as you will him to get over the high bar, or push that stepper one more notch
- Ocena
- 5 / 5
- Polubienia
- 162
- Pobrania
- 224
- Wydruki
- 5
- Wyświetlenia
- 3895
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I can't make up my mind if he's trying to wind the stepper or to stop it, but with every revolution of the stepper and every retraction there's a new and random action. Right now I am wasting more time watching him than I did making him.
I'd strongly recommend printing with a .25 nozzle, layer height doesn't matter, but a 0.4 nozzle will probably work OK. He really is quite small.
You'll need Magnets of course! 8mm x 2mm or smaller, just stack a couple on each side of the hub. If it's a bit close to the body of the stepper - space it with an extra magnet. Three magnets should be plenty!
Print in PLA - use the tiniest drop of Super Glue on a toothpick to keep the sockets together - just make sure you don't get any between the arms and legs and the body - I tend to keep moving them as the glue dries just to make sure.
The parts are tiny - so clean your bed with detergent before you start, the little circle on the end of the axle can be pinched off before assembly - it's just a bit of print insurance.