Modified Baddeley Door Hinge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a slightly modified hinge for the MKIII Baddeley R2-D2. It can be used in place of LowerHinge.stl and…
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 386
- Wydruki
- 0
- Wyświetlenia
- 1187
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This is a slightly modified hinge for the MKIII Baddeley R2-D2. It can be used in place of LowerHinge.stl and UpperHinge.stl.
When installing my servo-controlled doors, I noticed that my doors were not closing flush with the body - even when I used the "extra pull" version of the hinge that was intended to solve this issue by allowing the hinge arm to rotate a few additional degrees.
My investigation suggested that the actual cause of the problem was the existence of a gap causing a slight misalignment between the hinge arm and the fully closed door. I corrected this gap and misalignment by making the flat end of the hinge arm thicker than the stock part.
Additionally, I have opted not to use the flexible servo linkage parts and so I have replaced the slot that would normally receive the arrow-shaped end of the servo arm with a simple 2mm hole that can accommodate a standard 1mm wire linkage.
Print Settings
Supports:
No
Category: Robotics