IC-705 very portable table stand.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an ultra portable desk stand for the IC-705. It breaks down small enough to fit in a small envelope and take…
- Ocena
- 3,667 / 5
- Polubienia
- 20
- Pobrania
- 139
- Wydruki
- 2
- Wyświetlenia
- 1118
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is an ultra portable desk stand for the IC-705. It breaks down small enough to fit in a small envelope and take very little space in your go bag or back pack.
Print two of the cross member parts, and two of any of the angled sides you want.
Note: if the notches are too loose with your print, the cross member named "tighter notch" has a notch that's 0.2mm smaller.
There are four side pieces, one each for a different angle on the radio. You can have it angled up at 5, 10, 15, or 20 degrees.
To assemble, just put the notches together. The side pieces have an embossed number to indicate the angle the radio will be tilted up. The end with the number goes to the rear.
Print Settings
Printer Brand:
Anycubic
Printer:
All-metal Mega
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
25%
Filament: unknown PLA Black
Notes:
An easy and quick print. I used .2mm layer height to get good strong parts.
Category: Electronics