Fidget Spinner - Hoverboard / swagway
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Things needed: Board (qty 1) - either board will work the revised board is a little longer and has a snugger fit on…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 152
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Things needed:
Board (qty 1) - either board will work the revised board is a little longer and has a snugger fit on the axle
Axle (qty 2)
608 bearings (qty 3)
Rev 2: I tightened up the center bearing hole clearance. The bearing fit gets a bit loose after breaking it in. will make it a bit more difficult to assemblebut overtime I think it will last longer.
- Made 1 Tri version you'll need another bearing and 1 more axle
- Designed a skateboard version: http://www.thingiverse.com/thing:2310966
added thumb pads
-revised axel to make abit shorter and made bearing fit a little looser some bearings were very tight fits
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 V2
Rafts:
Yes
Resolution:
0.15
Infill:
100
Notes:
Printed in PLA (210 nozzle 65 bed temps)
probably get by with 50%infill but I like the spinners solid. axles printed vertically might be a bit stronger printed horizontal but they would probably need supports.I'll try one with 50% and .2 resolution to cut print time down
Category: Toys & Games