Parts for Kreg Swing Stop
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
After printing the Kreg_swing_stop (https://www.thingiverse.com/thing:1894699) by wwwayne, I found I wasn't sure how…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 238
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
After printing the Kreg_swing_stop (https://www.thingiverse.com/thing:1894699) by wwwayne, I found I wasn't sure how to assemble it. I checked out the actual item and discovered there were several bushings and a stop. I fired up SolidWorks and went to work. These are the results. I have included the Solidworks files for anyone who wants to adjust or customize these.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Resolution:
0.2
Filament:
Overture PET-G
Grey
Notes:
Bed: 85/80°C (1st layer/Print)
Nozzle: 245°C
First Layer: 0.4mm
Post-Printing
REQUIREMENTS
Prints:
1 - FT4258 Support Stop
4 - FT4257 Stop Bushing
Hardware:
1 - 5/16" x 3" Hex Bolt
2 - 5/16" Flat Washers
1 - 5/16" Nyloc Nut (or simialr locking nut)
ASSEMBLY
- Insert the 4 bushings in the swing arm parts. Place a flat washer on the bolt. Insert the bolt into the bushing on the Swing Arm and slide it through the bushing on the other side. Insert the bolt into the bushing of the Support and slide it through. Place a washer and nut on the end of the bolt and tighten. Insert the stop in the support (I printed a second stop and placed it in the other hole as well.)
Category: Parts