1 / 3
ANET A8 X-BELT TENSIONER 1/4-20 SCREWS (WIDE PULLEY)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I bought replacement idler pulleys and they were a bit too wide to fit the original x-axis tensioner design. I tried…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 406
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I bought replacement idler pulleys and they were a bit too wide to fit the original x-axis tensioner design. I tried sanding out the inside of the X-axis tensioner, but I still ended up with too much friction and skipped steps because of it.
This x-axis tensioner for the Anet A8 has .4 inch width for the idler pulley instead of the original .335 in width.
Also, the intended hardware for this is 1/4-20 nylock nuts and bolts.
Category: 3D Printer Parts