Rubber Band boat remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of Bigsbigley135's paddle powered boat. I only did one tiny small thing. I added an angle to the…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 408
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
This is a remix of Bigsbigley135's paddle powered boat. I only did one tiny small thing. I added an angle to the overhang where the rubber band hooks over the post in the middle of the boat. This is so the boat can be printed bottom side down without needing any support ant that post will look clean. As it turns out this is a nice print.
I did not include the paddles or axle in my listing. You'll still have to go to Bigsbigley135's original thing to get it. https://www.thingiverse.com/thing:1299088
Infill at 30% gives it enough heft to be stable in the water and a lot of air pockets to keep it afloat.
Print Settings
Printer Brand:
Creality
Printer:
CR10S PRO
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
30
Notes:
I used 30% infill to give it some weight and to make it stable in the water. It has a nice feel to it.
Category: Mechanical Toys