Sherpa/Dragon mount for HEVO
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted to use Sherpa mini and Trianglelab Dragon on my Hypercube evolution. But i coudn't find the mount for it. So…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 265
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted to use Sherpa mini and Trianglelab Dragon on my Hypercube evolution.
But i coudn't find the mount for it. So I've decided to give it a try and make my own.
The mount plate for sherpa/dragon has no space for end stops, if you want use them (as in oryginal design) you need to print x-carriage as wel. If not the mount plate should fit on standard hevo x-carriage.
Front plate is mixed from the sherpa mount I've found on official sherpa mini Github from annex-engineering. The cooling fans ducts are comming from the same design as wel.
If needed you can use BLTouch mount, but i dont really like this design.(It is too far away from the nozzle, but I didn't find a better place for it)
The offset is Y-70mm,X-0
Use wel heat resistant filament especially for blower mount(I used nylon)
Print Settings
Printer:
Artillery Genius
Rafts:
No
Resolution:
0.2
Infill:
25
Filament: Extrudr, Fiberlogy ASA, PA, Green TecPRO
Category: 3D Printer Extruders