Overlord Pro Double Lack enclosure

To reduce the noise and improve quality I decided to create an enclosure for my Overlord Pro. The printer is very noisy and sometimes is hard to print ABS. So I decided to create something like the famous Lack Enclosure

https://www.thingiverse.com/thing:2012384

But due to the height of the printer, a delta, I created the double Lack enclosure. Basically I joined two lack table, but not one over the other, but faced. So I get the double of the height that is a little bit more than my printer height.

With some bracket I joined the two tables. One up, and one down joined by the legs. I joined the 4 legs just to be sure that the enclosure was rigid. After that I covered 3 sides of the enclosure with a plastic cover I already got, methacrylate can also be used of course, and the last one side was covered with methacrylate to create the door. With 2 hinges and a pair of magnets I finished the door. Even I placed some white cork inside the plastic covered walls to improve the insulation.

I placed the Overlord Pro plastic tray outside the printer, so the material now is outside the printer, so you can change it from outside. I just drilled a hole and used a PTFE tube to insert the material to the printer extruder.

Now I need to finish the door and improve the overall project.

I also create a Door handle to use with the door magnets I got.

Category: 3D Printing