Quick Release Snap Shackle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A quick release shackle, pull the pin and the latch opens.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 684
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
I needed a quick release shackle to allow my students egg droppers to drop easily from a beam hanging from the ceiling.
The latch can print with no supports or brim.
The main body needs to be printed with supports everywhere (would block the supports in the tube through the body)
The pin is best printed in the orientation it is in currently as printed vertical, it can break apart along the layer lines.
If you find the pin too weak, replace with a piece of M6 threaded rod roughly 70mm in length, with a nut on it to hold the spring in.
Construction -
- Remove all supports
- Bolt the two main pieces together
- Place the spring on the pin
- Place the pin and spring inside the main body and use the split ring to keep it in place
- Pull the pin out as you close the latch
- Pulling the pin via the split ring releases the latch
You will also need
- 1 M6 50mm in length bolt
- M6 nut
- Split ring to go through the pin
- 11mm od, 8mm id spring, 25mm in length- I ordered mine from here https://springsandthings.me.uk/shop/compression_springs/11mm-compression-springs/
Optional - if pin is too weak.
- M6 threaded rod
- M6 nut