3D Higher Model Rocket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rocket Designed to fly off 29mm motors for best performance. The Rocket glues (super glue / CA glue) together Rail…
- Ocena
- 5 / 5
- Polubienia
- 49
- Pobrania
- 387
- Wydruki
- 5
- Wyświetlenia
- 1772
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Engineering
- Licencja
- Creative Commons — Attribution — Noncommercial
Rocket Designed to fly off 29mm motors for best performance.
The Rocket glues (super glue / CA glue) together
The pieces stack from Top→Down as follows
- Nose Cone, BS3, BS2, BS1, FINCAN
Rail buttons can be mounted to the printed holes (be sure to line these up as you glue it together).
You can alternatively glue a standard Estes launch lug to the exterior (Uses lots of glue if you take this path).
Recommend using thin kevlar shock cord to tie between motor mount and nose cone.
Motor mount screws in with (3) 4-40 x 1/2 in screws.
Nose cone infill is adjusted to adjust rocket stability (aka weighting the nose cone)
Warning if parachute is packed improperly rocket will CATO at apogee.
Video of build available: https://youtu.be/tL4k_gFz-PA
Early Prototype Test Launch: https://youtu.be/ScVH8IsliAU
Other Rocket Designs can be found at: https://inverted-pursuits-lab.square.site/
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
15%
Filament: NA PETG NA
Notes:
Weight of nose cone can be adjusted by changing infill of that part to help stabilize the rocket
How I Designed This ===================
Rocket missing 1 body section
Category: DIY