Geometric Succulent Planter for vase mode / spiralize outer contour
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of "Modern geometric Succulent plant pot" (thing:4591435). Printable with spiralize outer contour.
- Ocena
- 5 / 5
- Polubienia
- 84
- Pobrania
- 527
- Wydruki
- 1
- Wyświetlenia
- 2116
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of "Modern geometric Succulent plant pot" by “SchulteGeileTechnik” (thing:4591435). The things are designed solid now. Edges were smoothed and some parts were resized and cut.
One can adjust the wall thickness to the desired value using his slicer software. Use "Spiralize Outer Contour" (vase mode, best results) or modify the wall line count, set top layer thickness to 0 mm and set infill to 0 %. The bottom thickness is recommended to be 3 mm. Otherwise there will be a hole in the planter due to the little stand.
----Best results Cura settings, Spiralize Outer Contour: On----
----Top/Bottom----
Top Thickness: 0 mm
Bottom Thickness: 3 mm
----Support----
Support: On
Overhang Angle: 80 °
----Special Modes----
Spiralize Outer Contour: On
----Alternative Cura settings, Spiralize Outer Contour: Off----
---- Walls----
Wall line count: 3 or higher recommended for 0.4 mm nozzle
----Top/Bottom----
Top thickness: 0 mm
Bottom thickness: 3 mm
---- Infill ----
Infill density: 0 %
----Support----
Support: On
Overhang Angle: 80 °
Notes: Printed with 0.6 mm nozzle
Filament: Silver PETG