Misumi 2040 Endcap Joiners
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted to repurpose some Misumi 2040 I had laying around from an old AM8 printer and decided I wanted to try to use…
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 107
- Wydruki
- 1
- Wyświetlenia
- 598
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I wanted to repurpose some Misumi 2040 I had laying around from an old AM8 printer and decided I wanted to try to use it for the table of my upright Dewalt portaband saw. I tried multiple configurations ranging from using all double couplers as seen in the picture to making large single piece units to test strength. Spoiler: I did not notice much difference in strength between the smallest to the largest units nor between PLA and PETG. If anything PETG broke a little easier, as both had a small amount of deflection across the run. These have holes in the caps designed to accept a M5 bolt since I threaded the center of each of my 2040 extrusions.
I must mention I have my machine dialed in pretty tight and designed these pieces to fit VERY snug to reduce as much slop or play making it as solid as possible. I recommend printing these slower and with at least 30% infill and extra walls.
Once I settle on a method of attachment to my saw I'll update this more as there may be some new parts.
Print Settings
Printer:
Qidi X-Plus
Rafts:
No
Supports:
No
Resolution:
.15
Infill:
30% or more
Filament:
Hatchbox PLA
Green
Category: Parts