Pwnagotchi Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of "Waveshare display (v1/v2) with a PiSugar 1200mAh battery and a carabiner loop" to support the…
- Ocena
- 5 / 5
- Polubienia
- 47
- Pobrania
- 761
- Wydruki
- 3
- Wyświetlenia
- 5353
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
This is a remix of "Waveshare display (v1/v2) with a PiSugar 1200mAh battery and a carabiner loop" to support the PiSugar2 1200mAh (switched USB charging port/button, and added a slot for the power switch).
I made the case and lid a little "fatter" to better support the PiSugar2 (only 1mm, but it made a world of difference), and added heat dissipation slots in the lid, and I've also included a slightly larger button (the original "slipped" a little sideways when I tried using it).
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.15
Infill:
15%
Filament: Filamentive PETG Orange
Notes:
To get an interference fit on the lid, I needed to make it a little larger than "as supplied"; height was fine, but needed 0.5mm added to width and length). YMMV.
Category: Gadgets