PVC canopy
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A challenge was laid down infront of me to build a bed fort. Using the mounting holes for an upper bunk bed and 1in…
- Ocena
- 0 / 5
- Polubienia
- 62
- Pobrania
- 245
- Wydruki
- 0
- Wyświetlenia
- 2131
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
A challenge was laid down infront of me to build a bed fort.
Using the mounting holes for an upper bunk bed and 1in PVC, this was my answer.
pieces:
- base mount . accepts the vertical and 45deg support. The 2 piece version allows for printing without supports and some versatility in mounting the frame to different surfaces. Adapters will be added as applications see fit.
- Corner. initially intended to use pieces from the hardware store, but none were available. this is an XYZ orientation that should be obvious. the flat back version needs no support.
- Strut support. Hollow piece slides freely to allow for fine tuning before tightening the set screw. 'Clean' version removed all the ugly failed seams, chamfers and pipes covering inconsistencies that I still haven't quite mastered.
I printed these with 22% infill and 2mm walls. they shouldnt need the extra strength, but it couldnt hurt.
Update 7/10/2019. replaced the threaded base with refactored internal thread.
Print Settings
Printer Brand:
Monoprice
Printer:
Select Mini
Rafts:
No
Supports:
No
Resolution:
'normal'
Infill:
22
Filament: Inland PLA+ Red
Notes:
No supports are required only if printing the two remix pieces that dont need them. Orient the pieces so that the max angle is 45 and you should be fine.
Category: Decor