Kalita Wave 185 Coffee Filter Reshaper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The Kalita Wave 185 coffee dripper makes a great cup of coffee, but the filters are ridiculously expensive. They're…
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 1314
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
The Kalita Wave 185 coffee dripper makes a great cup of coffee, but the filters are ridiculously expensive. They're $17 USD for 100 (17 cents per filter), which I refuse to pay.
Standard flat-bottom 8-12 cup coffee filters (the larger ones) only cost about 1-2 cents each and can be reshaped with this jig I designed and 3D printed.
Hardcore Kalita Wave fanatics will be horrified that the reshaped filter doesn't have a perfect "wave shape", but I've been doing this for over 4 years and can't taste any difference between the official filters and the reshaped cheap ones. They're completely welcome to keep spending $17 per 100 filters.
There's enough gap between the plunger and base that you can do about 8 or so filters at a time, so you can rip through a box of 100 filters in a few minutes. I've found the Bunn filters sold at Walmart for $2 are the best.. they're a little taller than average which helps.
You might think the smaller 1-4 cup size filters would be better, but they end up being too short and don't make it all the way up to the top of the Kalita Wave 185.
There are 3 STL files here. One for the base, one for the plunger and one for the set. No supports are required.
FreeCad source is included if you want to modify the design. Please share any mods if you do.
Print Settings
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
No
Resolution:
0.28
Infill:
20%
Filament: any any any
Notes:
no need for any supports. I set the wall thickness to about 1mm in Cura.
Category: Kitchen & Dining