Home Depot Bucket Funnel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This creates a funnel inside of a 5 gallon Home Depot bucket to route dry material down to a hole in the center of the…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 101
- Wydruki
- 0
- Wyświetlenia
- 2273
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
This creates a funnel inside of a 5 gallon Home Depot bucket to route dry material down to a hole in the center of the bottom.
It's not a complete solution on its own, and is the first step in a DIY salt spreader that I'm working on, but it could be adapted for seeds, dry food, or the like.
In the future, hope to have a shaft going down the middle with a spreader plate spun by a 18V drill or similar. There also needs to be a gate or valve to control the flow of salt. Unlike commercial seed/salt spreaders I plan to just carry it instead of using wheels. Some kind of legs will be required to keep the spreader plate from hitting the ground.
Maybe I'll never complete it, I don't know, but this is a first step that you might be able to use for something else.
The 4 quarters fit pretty snugly, but builders adhesive or caulking might be a good idea for the finished project.
FreeCad 0.18 source is included.
Print Settings
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
Doesn't Matter
Supports:
No
Resolution:
Wall thickness 1mm or greater. Layer height as high as possible.
Infill:
0% -10%
Filament: any PLA, ABS or any really any
Notes:
You need to print 4 of the quarter wedges to make a full funnel. It will print without any infill, or very little.
These take rather long to print and the quality isn't that critical, so push the limits on layer height and speed. I was able to print 2 at a time but each set took nearly a day.Category: Outdoor & Garden