Ryobi 18V Battery Connector and Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ryobi 18V Battery Connector and Box for two batteries. Based on existing designs but added terminal/clip clamp.
- Ocena
- 5 / 5
- Polubienia
- 34
- Pobrania
- 189
- Wydruki
- 1
- Wyświetlenia
- 1435
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This Ryobi 18V Battery Connector allows you to power any device or power tool with Ryobi 18V Batteries. This connector can be used as the basis of an adapter to power non-Ryobi power tools or to power your electronic projects with Ryobi batteries. I am using this adapter as part of a two battery system for my R2-D2.
This is a remix of the Ryobi 18V Battery Connector by henryarnold on Thingiverse, which in turn was a remix of this model.
I've added a cap to secure the clips which I found would eventually work their way loose. It also doubles as a bit of a cable strain relief. The clamp is secures with a small 4-40 flat head screw.
I built two of these connector setups into a box which is partially printed (Ryobi_Batt_Box_Sides_V1). The goal was to try and fit two Ryobi batteries into the footprint of one 18AH SLA Battery. The beefy support/sides are printed but I used some scrap plastic to create the top/bottom etc. which was much quicker and easier than printing.
The reason the box is so tall is that I have a relay system inside to control both battery circuits simultaneously from one small switch.
Search for the Ryobi clips using "Keystone 209" on eBay or Amazon. Usually come in packs of 20 for around $8-10.
I would recommend printing in PLA or in a plastic that does not shrink. I had printed in ABS originally but the fit was way to tight.