1 / 1
25mm fan adapter to 40mm fan mount — zdjęcie 1

25mm fan adapter to 40mm fan mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter to allow a 25mm fan to be mounted as if a 40mm fan. Helpful for mounting a Raspberry PI 4 Case Fan with PWM to…

Ocena
4 / 5
Polubienia
20
Pobrania
221
Wydruki
1
Wyświetlenia
1165
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

Adapter to allow a 25mm fan to be mounted as if a 40mm fan. Helpful for mounting a Raspberry PI 4 Case Fan with PWM to a non official Raspberry PI case that would normally use a 40mm fan.

Used supports from the bed for the nut mounts. No other support necessary to print. Used existing 3mm screws and nuts to mount.

You will need to remove the Dupont connector while you push the wires through the hole. But that is pretty easy. Makes for a very clean install.

Print Settings

Rafts:

No

Supports:

Yes

Notes:

Supports are only necessary from the bed and only for the nut holders. Let me know if you have any idea on how to design without needing any support.

Post-Printing

Just some slight clean up around the nut holders

How I Designed This

Fusion 360

Category: Electronics

Tagi